Retrofit projects

Cap feeder retrofit for existing capping machines.

Upgrade a manual or unreliable cap loading process with an automatic feed route matched to your current capper.

Need the feeder to match your cap and capper?

Send cap samples, photos, target output and the downstream capping machine details. The quickest shortlist starts with real parts, not a generic speed figure.

Send cap details

Specification focus

A retrofit starts with space, handover and controls.

Adding a cap feeder to an existing capping machine can reduce manual loading and improve consistency, but the retrofit must work with the machine already on site.

The key checks are available footprint, discharge height, guarding, capper handover, electrical signals and how the operator currently loads caps. Photos and dimensions are very useful at the first stage.

A retrofit may use a bowl feeder, hopper, elevator, sorter, chute or a combined system depending on the closure and the current capper design.

Use existing equipmentDesign around the capper and conveyor already installed.

Reduce manual loadingMove from hand loading to controlled cap supply where practical.

Plan safe integrationCheck guarding, access, sensors and electrical interfaces.

Selection table

Key checks before specifying the feeder.

Check	Why it affects the design	What to send
Available space	Determines feeder footprint and access.	Send plan-view photos and rough dimensions.
Handover point	The feeder must reach the capper correctly.	Send close photos of current cap loading point.
Controls	Start-stop and fault signals may be needed.	Send control-voltage and machine information if available.

Related routes

Continue with the nearest cap feeder route.

These supporting pages help match the closure, capping machine and line layout to the right handling method.

IntegrationConnect feeders to cappers, conveyors and controls. Feeders for capping machinesMatch the feeder to the downstream capper. Automatic cap feedersBulk storage, sorting and cap delivery for capping machinery. Request a quoteSend cap samples and line details for advice.

FAQs

Questions about cap feeder retrofit.

Can a cap feeder be retrofitted to any capper?

Not every capper, but many existing machines can accept a feeder if space and handover conditions are suitable.

Do you need a site visit?

Photos, samples and dimensions can start the review. A visit may be useful for complex or tight layouts.

Will the retrofit increase speed?

It can reduce manual loading and missed caps, but final speed is limited by the capper, closure and line behaviour.